Computer Setting; Adjusting The Viewing Angle - Iiyama ProLite T1731SAW-B5 User Manual

COMPUTER SETTING

 Signal Timing
Change to the desired signal timing listed on page 29: COMPLIANT TIMING.
 Windows XP/Vista/7/8/8.1/10 Plug & Play
The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs
on Windows XP/Vista/7/8/8.1/10 by connecting the monitor to DDC2B compliant computer with
the Signal Cable supplied.
For installation on Windows XP: The monitor Information File for iiyama monitors may be
necessary for your computer and obtained via the Internet, using the address:
NOTE
 For additional information on how to download the driver for your touch screen monitor,
please access the internet site noted above.
 Monitor Drivers are not required in most cases for Macintosh or Unix operating
systems. For further information, please contact your computer dealer fi rst for advice.
 Procedure for turning ON the Power Switch
Turn ON the monitor fi rst, and then the computer.
 Touch screen driver software
Touch screen driver software and system may not start when you start your computer while
touching the screen.
Touch screen driver software may not run due to the power saving function depending on the
BIOS of your computer. In this case, set the power saving function to off .

ADJUSTING THE VIEWING ANGLE

 For optimal viewing it is recommended to look at the full
face of the monitor.
 Hold the panel so that the monitor does not topple when
you change the monitor's angle.
 You are able to adjust the monitor's angle up to 90
degrees upward, 5 degrees downward.
NOTE
 Do not touch the LCD screen when you change
the angle. It may cause damage or break the
LCD screen.
 Careful attention is required not to pinch your
fingers or hands into the moving part of the
stand when you change the angle.
8 BEFORE YOU OPERATE THE MONITOR
http://www.iiyama.com
90°
5°