Page 1
DVI to HD-SDI Conversion Box U S E R M A N U A L www.gefen.com...
Page 2
Chatsworth, CA 91311 www.gefen.com support@gefen.com Gefen Inc. reserves the right to make changes in the hard ware, packaging and any accompanying doc u men ta tion without prior written notice. The DVI to HD-SDI Conversion Box is a trademark of Gefen Inc.
Gefen's DVI to HD-SDI Conversion Box is a universal DVI-D / SDI (HD and SD) converter. It converts DVI-D to SDI (SD or HD digital YPbPr). It automatically detects the input scan rate and supports a wide variety of video formats including PAL, NTSC, 720p, 1080p, 1080i.
On power up, the DVI to HD-SDI Conversion Box will automatically detect the input format of the input. Resolution The factory default is 720p-59.94. If your SDI monitor does not support that mode and cannot display a picture to allow you to use the OSD, you can cycle through the output mode according to the following table: PAL ->...
PANEL DESCRIPTIONS DVI-D Input 5V Power RS-422 HD-SDI Connector Uplink Port Output...
Page 7
All DVI-D interlaced and progressive scan formats up to 1920x1200 OSD and INFRARED REMOTE FUNCTIONS The DVI to HD-SDI Conversion Box works with the Gefen RMT-4IR remote control. Button 1 - Displays source and display information Button 2 - Resets the Conversion Box to default settings (requires power cycle)
RMT4-IR Installation 1. Remove battery cover from the back of the RMT4-IR remote. 2. Verify that dip switches 1 & 2 are in the up (ON) position. 3. Insert the battery, hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down.
You can make the cable using the wiring diagram shown at the end of this document or purchase a cable form KK Systems. Note: For a true RS422 connection, you can use an adapter made by KK Systems (Part Number K422-99). This adapter connects to the RS232 port on the PC and provides an RS422 connection on the other side.
FIRMWARE UPDATE PROCEDURE To upgrade the fi rmware of the DVI to HD-SDI Conversion Box, you need to have the DVI to HD-SDI Conversion Box RS422-PC cable. You also need to have the 3 fi les HDVI20.exe, HDVI-20_Uploader.bat and the HDVI-20 bin fi le (version 1.30 or higher, DO NOT USE ANY EARLIER VERSION) in your DOS directory.
SPECIFICATIONS Input ... DVI-D up to 1920x1200 progressive scan and 1080i formats Output ... SD-SDI SMPTE 259M, HD-SDI SMPTE 292M and 720p-50 Power Supply ... 5V DC Power Consumption ... 10 watts (max) Dimensions ... 5.5”W x 1”H x 3.75”D Shipping Weight ...
If equipment fails because of such defects and Gefen Inc. is notifi ed within one (1) year from the date of shipment, Gefen System will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical or other abuse or modifi...
Need help?
Do you have a question about the DVI-2-HDSDI and is the answer not in the manual?
Questions and answers