Panasonic PT-RZ660 Operating Instructions Manual page 64

Chapter 3 Basic Operations — Switching on/off the projector
f To set the projector based on luminance
[MAX LIGHT
Luminance (lm)
OUTPUT LEVEL]
6 000 100.0
5 500 100.0
5 000 100.0
4 500 100.0
4 000
100.0
3 500 100.0
3 000 100.0
2 500 100.0
2 000 100.0
Note
f The runtime may be shorter than the estimation due to the influence of characteristics of each light source, conditions of use, installation
environment, etc.
f The duration of use is referred to as the runtime when you use the projector successively. The duration of use is an estimated duration and
is not the warranty period.
f If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
Initial setting (installation setting)
Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.
Refer to "Installation mode" (x page 35) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1) Press qw to switch the setting.
2) Press the <ENTER> button to proceed to the initial setting.
64 - ENGLISH
When [CONSTANT MODE] is set to [OFF]
[LIGHT OUTPUT]
(%)
(%)
100.0
92.0
83.0
75.0
67.0
58.0
50.0
42.0
33.0
INITIAL SETTING
PROJECTION METHOD
FRONT/REAR
FLOOR/CEILING
Change the projection method (FRONT/REAR,
FLOOR/CEILING) if the screen display is upside down
or inverted.
MENU SELECT
SET
ENTER
When [CONSTANT MODE] is set to [AUTO] or [PC]
[MAX LIGHT
Runtime (hour) OUTPUT LEVEL]
(%)
20 000 ―
22 000 100.0
24 000 100.0
26 000 100.0
28 000 100.0
29 500 100.0
31 500 100.0
33 500 100.0
35 000 100.0
3/7
FRONT
AUTO
CHANGE
[LIGHT OUTPUT]
Runtime (hour)
(%)
― ―
― ―
83.0 4 000
75.0 7 000
67.0 11 000
58.0 16 000
50.0 22 500
42.0 30 000
33.0 39 000