JETWAY LA0H Series User Manual page 32

USB Mass Storage Driver Support
Use this item to Enable or Disable USB Mass Storage Driver Support.
The optional settings are: [Disabled]; [Enabled].
USB hardware delays and time-out
USB Transfer Timer-out
The time-out value for Control, Bulk, and Interrupt transfers.
The optional settings: [1 sec]; [5 sec]; [10sec]; [20 sec].
Device Reset Timer-out
USB mass storage device Start Unit command timer-out.
The optional settings: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device Power-up Delay
Use this item to set maximum time the device will take before it properly reports
itself to the Host Controller.
The optional settings:[Auto]; [Manual].
Select [Manual] you can set value for the following sub-item: 'Device power-up
delay in seconds', the delay range in from 1 to 40 seconds, in one second
increments.
Network Stack Configuration

Press [Enter] to go to 'Network Stack' screen to make further settings.
Network Stack
Use this item to Enable or Disable UEFI network stack.
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Ipv4 PXE Support
Use this item to enable Ipv4 PXE Boot Support. When set as [Disabled], Ipv4 boot
optional will not be created.
The optional settings are: [Disabled]; [Enabled].
Ipv6 PXE Support
Use this item to enable Ipv6 PXE Boot Support. When set as [Disabled], Ipv6 boot
optional will not be created.
The optional settings are: [Disabled]; [Enabled].
PXE boot wait time
Use this item to set wait time in second to press [ESC] key to abort the PXE boot.
Use either +/- or numeric keys to set the value.
Media detect count
Use this item to set number of times the presence of media will be check.
Use either +/- or numeric keys to set the value.
CSM Configuration

Press [Enter] to make settings for the following sub-items:
Compatibility Support Module Configuration
CSM Support
Use this item to enable or disable CSM Support.
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Option ROM execution
Network
Use this item to control the execution of Network OpROM.
28