JETWAY LA0H Series User Manual page 30

Use this item to set CPUFAN full speed duty. Fan will run at full speed when
above the pre-set duty.
CPUFAN Idle-Speed Temperature
Use this item to set CPUFAN idle speed temperature. Fan will run at idle speed
when below this temperature.
CPUFAN Idle-Speed Duty
Use this item to set CPUFAN idle speed duty. Fan will run at idle speed when
below the pre-set duty.
Serial Port Console Redirection

Press [Enter] to make settings for the following sub-items:
COM1
Console Redirection
Use this item to enable or disable Console Redirection.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
Console Redirection Settings

Press [Enter] to make settings for the following sub-items:
Terminal Type
The optional settings are: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
Emulation: [ANSI]: Extended ASCII char set; [VT100]: ASCII char set; [VT100+]:
Extends VT100 to support color, function keys, etc.; [VT-UTF8]: Uses UTF8
encoding to map Unicode chars onto 1 or more bytes.
Bits per second
Use this item to select serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings are: [9600]; [19200]; [38400]; [57600]; [115200].
Data Bits
The optional settings are: [7]; [8].
Parity
A parity bit can be sent with the data bits to detect some transmission errors.
The optional settings are: [None]; [Even]; [Odd]; [Mark]; [Space].
[Even]: parity bit is 0 if the num of 1's in the data bits is even; [Odd]: parity bit is 0 if
num of 1's in the data bits is odd; [Mark]: parity bit is always 1; [Space]: Parity bit
is always 0; [Mark] and [Space] Parity do not allow for error detection. They can
be used as an additional data bit.
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow devices
may require more than 1 stop bit.
The optional settings are: [1]; [2].
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a "stop" signal can be sent to stop the data flow. Once
the buffers are empty, a "start" signal can be sent to re-start the flow. Hardware
flow control uses two wires to send start/stop signals.
The optional settings are: [None]; [Hardware RTS/CTS].
VT-UT F8 Combo Key Support
26