Checking The Lamp Life Status; Keylock Function - Sharp XR-H825XA Manual

5
Enter the same keycode in "Re-
confirm".
To cancel the keycode that you have already
set
• Press R on the projector for four times in steps
4 and 5 above.
When the System Lock is set
• When System Lock is set, the keycode input
screen appears after the power is turned on.
When it appears, enter the right keycode to
start projection.
Input screen for keycode
Checking the Lamp Life
Status
You can confirm the cumulative lamp usage time
and the remaining lamp life (percentage).
Lamp usage condition
"Life"
Operated exclusively
with Lamp Setting set to
"Eco +Quiet"
Operated exclusively
with Lamp Setting set to
"Bright"
• It is recommended that the lamp be changed
when the remaining lamp life becomes 5%.
• The lamp life may vary depending on the us-
age condition.
Remaining lamp life
100% 5%
Approx. 4, Approx.
000 hours 200 hours
Approx. 2,
000 hours Approx.
100 hours

Keylock Function

Locking the Operation
Buttons on the Projector
Use this function to lock the operation buttons
on the projector.
a Locking the Operation Buttons
Hold down ENTER on the projector for about 5
seconds while the projector is being turned on.
On-screen display
• The keylock function does not affect the opera-
tion with the remote control buttons.
• You cannot use the keylock function while the
projector is warming up.
a Taking the Keylock off
Hold down ENTER on the projector for about 5
seconds.
On-screen display
• When the projector is in standby mode, you can
release the keylock by holding down ENTER
and STANDBY/ON on the projector simulta-
neously for about 5 seconds.
• Keylock cannot be set while the projector is:
displaying the "Setup Guide" or "Menu"
screens, in standby mode, warming up, chang-
ing input signals, operating "Auto Sync" func-
tion, in "FREEZE" mode or on the "System
Lock" screen during warming up.
47