Advertisement
Quick Links
Advertisement
Related Manuals for Gefen HDMI-244
Summary of Contents for Gefen HDMI-244
- Page 1 2x4 HDMI Switcher/Splitter U S E R M A N U A L www.gefen.com...
- Page 2 Chatsworth, CA 91311 www.gefen.com support@gefen.com Gefen Inc. reserves the right to make changes in the hard ware, packaging and any accompanying doc u men ta tion without prior written notice. 2x4 HDMI Switcher/Splitter is a trademark of Gefen Inc. HDMI is a trademark of hdmi.org ©...
-
Page 3: Table Of Contents
Introduction Features Panel Descriptions Connecting and Operating the 2x4 HDMI Switcher/Splitter RMT2-IR Installation IR Code Confl icts Dip Switch Guidelines Specifi cations Warranty TABLE OF CONTENTS... -
Page 4: Introduction
Our Commitment Gefen will always offer the fi nest quality product at the best possible price. Included in that price is a lifetime support from a team of outstanding engineers. The ex•tend•it 2x4 HDMI Switcher/Splitter allows two HDTV HDMI devices to be dis- tributed easily in to four HDTV HDMI compatible monitors or projectors. -
Page 5: Features
FEATURES Features • Switches easily between any two DVI/HDMI sources • Maintains 480i, 480p, 720p, 720i, and 1080i, 1080p resolutions • Maintains highest HDMI single link video resolution • Maintains highest HDMI digital audio signal • Supports HDCP compliant devices •... -
Page 6: Panel Descriptions
PANEL DESCRIPTIONS... -
Page 7: Connecting And Operating The 2X4 Hdmi Switcher/Splitter
CONNECTING AND OPERATING 2x4 HDMI SWITCHER/SPLITTER How to Connect the 2x4 HDMI Switcher/Splitter to your devices 1 Connect the supplied cables from the HDTV HDMI sources into the 2x4 HDMI Switcher/ Splitter inputs. 2 Connect the cables from your displays (monitor or projector) into the HDMI outs of the 2x4 HDMI Switcher/Splitter. -
Page 8: Rmt2-Ir Installation
1. Remove battery cover from the back of the RMT2-IR remote. 2. Verify that dip switches 1 & 2 are in the down (OFF) position. 3. Insert the battery, hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down. -
Page 9: Ir Code Confl Icts
There are matching pairs of dip switches underneath the Switcher unit and under the remote battery cover. Switch 1 & 2 on the Remote and Switch 3 & 4 inside the unit are the matching switches. These switches need to be matched for the remote to communicate with the switcher. -
Page 10: Dip Switch Guidelines
1, 2, and 5. Please refer below for the different EDID modes. To access the Dip Switches, remove all screws from the bottom and sides of the Gefen unit. Carefully slide the unit apart. The 8 Bank of Dip Switches are located on the main PCB. -
Page 11: Specifi Cations
SPECIFICATIONS Video Amplifi er Bandwidth...2.25 GHz Input Video Signal...1.2 volts p-p Input DDC Signal...5 volts p-p (TTL) Single Link Range...1080p/60 10 bit color depth, 1920x1200 HDMI Connector...type A 19 pin female Power Supply...5V DC Power Consumption...10 watts (max) Dimensions...12”W x 1.25”H x 4.25”D Shipping Weight...6 lbs.