Using Remote Control; Installing And Removing Battery; Setting Remote Control Id Numbers - Panasonic PT-CW330EA Operating Instructions Manual

Hide thumbs Also See for PT-CW330EA:
Table of Contents

Advertisement

Using Remote control

Installing and Removing battery

1 )
Press the guide and pull
out the battery base.
Attention
When discarding a lithium coin battery, be sure both sides (+/-) are covered with adhesive insulating tape, such as and the
z
cellophane tape, and discard it according to the instructions of the local government.

Setting Remote control ID numbers

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the remote control ID of the projector, set the same remote control ID to the remote control.
There are 7 different remote control IDs: [All], [ID1]~[ID6], the initial remote control ID is [All].
Setting the remote control ID
J
1) While holding down the <MENU> key, press the <IMAGE> key. The number of times you press the
<IMAGE> key corresponds to the desired remote control ID.
The number of times to press the <IMAGE> key is as follows:
ID1 = Once, ID2 = Twice, ID3 = 3 times, ID4 = 4 times, ID5 = 5 times, ID6 = 6 times.
2) The remote control ID is changed when the <MENU> button is released.
Resetting the remote control ID
J
1) The remote control ID is reset to [All] (default) by pressing the <MENU> key and <IMAGE> key at the
same time for 10 seconds or more.
Note
When operating the projector under [All] code, you can operate several projectors at the same time.
z
If the <IMAGE> button is pressed 7 times or more, the remote control ID cannot be changed (the operation is invalid).
z
For setting the remote control ID codes, see [Remote ID] in the [Setting] menu. (
z
If the battery is not in use for a long period of time and is removed from the remote control, the remote control ID will be
z
reset.
2 )
Install new battery into the
compartment.
Remove the old
Lithium coin cell
battery and install
new one (CR2025).
Ensure that the side
with a "+" is facing
up.
Using Remote control
3 )
Put the cover back.
Æ
page 43)
ENGLISH -
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-cw240Pt-cw330uPt-cw330Pt-cw240eaPt-cx300ea

Table of Contents