Panasonic PT-DW10000U Operating Instructions Manual page 35

# $
Powering up the projector
# Connect the supplied power
cable. (120 V AC, 50 Hz/60 Hz)
$ Press the " | " marked side of the
MAIN POWER switch to turn on
the power.
• The power indicator lamp on the projector will
flash in red. After a short period, the indicator
will illuminate and the projector will enter
standby mode.
% Press POWER ON " | ".
• The power indicator lamp illuminates in green
and soon the image is projected on the screen.
Note
• If the projector is powered up at about 0 °C, a
warm-up period of approximately 5 minutes may
be necessary to start projection. The temperature
monitor (TEMP) lamp lights up during the warm-up
period. When the warm-up is completed, the
temperature monitor (TEMP) lamp turns off and the
image is projected on the screen.
• If the temperature of the operating environment is
low and warm-up takes more than 5 minutes, the
projector will judge that a problem has occurred
and the power will be turned off automatically. If
this happens, increase the temperature around the
projector so that it is 0 °C or higher, and then turn on
the MAIN POWER switch and the POWER ON " | "
switch once more.
) %
*
Making adjustment and
selection
& Roughly adjust the focus of the
( Select and set the projection
) Select the input signal by
* Adjust the tilt of the main unit in
+ Adjust the shift. (p. 37)
- Press AUTO SETUP if the input
. Fit the image size to the screen
/ Adjust the focus. (p. 37)
0 Display the zoom adjustment
( -, +-0 %
)
(
&, /
-
lens. (p. 37)
scheme. (p. 76)
pressing the input selector
button to toggle through RGB1,
RGB2, DVI-D, VIDEO, S-VIDEO
and AUX. (p. 43)
• The AUX button is disabled when an optional
input module is not connected.
front and rear or right and left.
(p. 20)
signal is RGB signal. (p. 44)
size. (p. 37)
menu again and adjust the zoom
to fit the image size to the screen
size. (p. 37)
-
+
.
35
ENGLISH –