Connection Of Inputs On The Standard And -S Models - ABB PVS-50-TL Product Manual

C
onnection of inputs on the Standard and -S models
For these two models connection with the DC input screw terminal block
is made by inserting the cables into the cable glands
To carry out the connections, the cables ( 13 to 21mm diameter) must
be passed through the DC cable gland
made to the DC input screw terminal block
accepts cables with a maximum-cross section of 95 mm
minum).
39
17
DC cable installation:
• Open the wiring box front cover
+ -
• Unscrew the DC cable gland
• Introduce the cable with a suitable cross-section
• Connect the cables to the terminals on the DC input screw terminal
block
nect the cables with the right polarity.
• Once connection to the DC input screw terminal block
completed, retighten (8.0 Nm torque) the cable gland firmly and check
seal.
• Check datasheet of terminal block to indicate which kind of cables are
allowed.
PVS-50-TL
PVS-60-TL
INPUT DC
OUTPUT AC
17
with a tightening torque of 20 Nm. During this operation con-
39
- 71 -
5 - Installation
.
17
. Connection of DC cables is
17
; the screw terminal block
39
(copper or alu-
2
PVS-50-TL-S
PVS-60-TL-S
39
INPUT
17
.
04
39
39
DC
OUTPUT AC
has been