Chapter 5. Configuring The Router; Login; Status - TP-Link MR4-WR642G User Manual

Chapter 5. Configuring the Router

This chapter describes each Web page's key functions.

5.1 Login

After your successful login, you can configure and manage the router. There are ten main menus
on the left of the Web-based utility. Submenus will be available after you click one of the main
menus. The eleven main menus are: Status, Quick Setup, Network, Wireless, DHCP,
Forwarding, Security, IP & MAC Binding Setting, Static Routing, DDNS and System Tools.
On the right of the Web-based utility, there are the detailed explanations and instructions for the
corresponding page. To apply any settings you have altered on the page, please click the Save
button.
The detailed explanations for each Web page key's function are listed below.

5.2 Status

The Status page displays the router's current status and configuration. All information is read-only
(shown in Figure 5-1).
1. LAN
This field displays the current settings or information for the LAN, including the MAC address,
IP address and Subnet Mask.
2. Wireless
This field displays basic information or status for wireless function, including Wireless Radio,
SSID, Channel, Mode, Wireless MAC address, and IP address.
3. WAN
These parameters apply to the WAN port of the router, including MAC address, IP address,
Subnet Mask, Default Gateway, DNS server and WAN connection type. If PPPoE is
chosen as the WAN connection type, the Disconnect button will be shown here while you
are accessing the Internet. You can also cut the connection by clicking the button. If you have
not connected to the Internet, just click Connect to establish the connection.
4. Traffic Statistics
This field displays the router's traffic statistics.
5. System Up Time
The total up time of the router from when it was switched on or reset.
MR4-WR642G 108M Wireless Router User Guide
15