Sending Scanned Data As An E-Mail Attachment; Before Using Scan To E-Mail - Oki MC573dn User Manual

Sending Scanned Data as an E-mail Attachment

This section describes how to send scanned data as an e-mail attachment.
•

Before Using Scan To E-mail

• Entering E-mail Address to Send E-mail
• Specifying a Destination from Address Book or Group List (Advanced Manual)
• Specifying a Destination Using One-touch Button (Advanced Manual)
• Specifying a Destination from Transmission History (Advanced Manual)
• Specifying a Destination Searching LDAP Server (Advanced Manual)
• Setting the Sender's Address (Advanced Manual)
• Setting the Reply Address (Advanced Manual)
• Registering an E-mail Template (Advanced Manual)
• Using an E-Mail Template (Advanced Manual)
• Saving Transmission Data (Advanced Manual)
• Checking Results of Scan To E-mail (Advanced Manual)
Before Using Scan To E-mail
If the machine is set up from [Easy Setup] > [E-mail Setting], skip Before Using Scan To E-
mail. If the information is not set, set up in the following procedure.
1
Check the information related to E-mail following the steps in
Setting Information".
2
Press [Device Settings] on the touch panel.
3
Press [Easy Setup].
4
Enter the administrator name and password, and then press [OK].
The factory default administrator name and password are "admin" and "999999" respectively. If the administrator
password is changed after installing the machine, enter the updated password.
5
Press [Skip>>] repeatedly to display [E-mail Setting].
6
Press [Next].
7
Follow the onscreen instruction to enter the information checked in Step 1.
E-mail Setup (Web Page) (Advanced Manual)
- 116 -
5. Scan
"Checking the