EIP CD85 Owner's Manual page 4

The CD85 covers can be swapped to allow the airflow direction to be changed
to better suit the application the unit is to be used for. To change the covers,
first remove the 4 off retaining screws and washers from each cover, swap
cover positions and replace 4 off retaining screws and washers. If changing
the evaporator covers then the filter retaining mesh should always be placed
behind the Evaporator Grille Cover. This is held in place with 4off M3 hex
head bolts.
Evaporator Grille Cover and Evaporator Blanking Cover are interchangeable.
Condenser Grille Cover and Condenser Blanking Cover are interchangeable.
Evaporator and Condenser covers are not interchangeable.
The different combinations available are shown below.
Evaporator Grille
Cover
(Air into machine)
Evaporator Grille
Cover
(Air into machine)
COVERS
Evaporator Blank Condenser Blank
Cover
(Blocks airflow) (Blocks airflow)
Evaporator Blank
Cover
(Blocks airflow)
Condenser Grille
(Air out of machine)
Page 4 of 15
Drawing : - TPC361
Issue
Date
Condenser Grille
(Air out of machine)
Cover
Condenser Blank
Cover
(Blocks airflow)
Cover
: - 1
: - 21/06/11
Cover