Table of Contents
Advertisement
•
If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient
– these stations can reconnect on, after many hours out.
•
RF (radio frequency) communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g. 100% humidity).
If a miss happens:
•
If sensor loses connection to the station for any reason, the station will show dashes after 30
minutes.
•
The station will search for 5 minutes every hour to reconnect with sensor.
•
Be sure you have good batteries. Manually search for your sensor.
Try this:
•
Bring your sensor within 10 feet of your station and make sure it is connected to the station.
•
After 15 minutes move the sensor into the next room with a wall between the sensor and the
station for 1 hour.
•
If there is no loss of signal in that hour, move the sensor just outside.
•
Continue moving the sensor back to its original location.
•
If you lose connection, look for sources of
HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?
•
On your sensor, open the battery cover and press the F/C button. This will change the
temperature display on the sensor only.
•
On your station enter the
on the station.
WHY ARE MY WIND CUPS NOT SPINNING?
•
Check for debris or ice preventing cups from moving.
•
Check mounting location. Look for obstructions that prevent the wind from reaching the
sensor.
•
In most cases, the wind sensor needs to be 4-6ft above the highest point on the roof in
order to clear nearby obstructions and read accurately.
•
A 50-foot clearance in all directions is best.
•
Push down firmly on the center of the cups to reseat them.
•
Cups are replaceable.
Occasionally, a bad storm with hail or debris that will damage your wind cups. These are easily
replaced.
Replace wind cups:
1. Loosen the screw on side of cups
2. Remove cups
interference.
program menu
to select Fahrenheit or Celsius temperature display
CAN I REPLACE MY WIND CUPS?
20 |
P a g e
Advertisement
Table of Contents
