Table of Contents
Advertisement
Battery
23
1.888.610.7664
After making sure that the power is off, remove the
1
rear cover on the back of the labelling system. If the
batteries are already in the labelling system,
remove them.
Make sure that the power is turned off when
replacing batteries.
Insert six new AA-size alkaline batteries (LR6), or
2
fully charged Ni-MH rechargeable batteries (HR6),
making sure that the positive (+) and negative (-)
ends of the batteries match the positive (+) and
negative (-) marks inside the battery compartment.
Users of alkaline batteries
Always replace all six batteries at the same
time using brand new ones.
Users of Ni-MH rechargeable batteries
Always replace all six batteries at the same
time with fully charged ones.
Attach the rear cover by inserting the three hooks
3
at the bottom into the slots on the labelling system,
then pushing down firmly until it snaps into place.
Remove the batteries if you do not intend to use the P-touch labelling system for an extended
period of time.
www.calcert.com
15
10
20
5
25
0
30
1
2
3
4
5
6
7
8
9
Power Supply
22
sales@calcert.com
Advertisement
Table of Contents
