Selecting How Tape Is Fed And Cut - Brother P-Touch PTE300VP User Manual

Selecting how tape is fed and cut

When printing, the message "Cut Tape or Press Enter to Continue" is displayed and goes
into [cut pause mode]. Pressing the Tape cutter lever, you can cut the tape at the position
you set in "Cut Option". The details are as follows.
•
•
•
1.888.610.7664
• When using Heat Shrink Tube, set labelling application type to "Cable Wrap" and select "Heat-
shrink Tube". In this case, cut option if fixed to "No Cut". After printing, remove the Heat Shrink
Tube cassette from the labelling system and use scissors to cut the tape.
• After printing, remove the Fabric Iron On tape cassette from the labelling system and use
scissors to cut the tape.
:Stop here and goes into [cut pause mode].
:Stop here and finish printing.
:Stop here and goes into [tape feed mode].
When the cut option is set to No Cut or Chain, it stops in the middle of printing area after the last
label is printed. After "OK to Feed?" is displayed, press OK key to feed tape. Press Escape key
to return to the entering text mode.
www.calcert.com
15
10 20
5 25
0 30
Small Margin
Large Margin
Chain
No Cut
1
2
3
4
5
6
7
8
9
40
Setting Cut Options
sales@calcert.com