Standby Mode; Schedule; Normal; Off - Panasonic PT-DW105XEA Operating Instructions (Functional Manual)

PROJECTOR SETUP menu
9 ) Display the internal test pattern [ALL
WHITE] on all projectors.
10) Set [BRIGHTNESS CONTROL GAIN]
of all projectors to 100 %.
11) Set [BRIGHTNESS CONTROL GAIN]
of the darkest projector to 90 %.
12) Adjust [BRIGHTNESS CONTROL
GAIN] of the other projectors to that
of the projector that was set to 90 %.
13) Set [MODE] of [BRIGHTNESS
CONTROL SETUP] of all projectors to
[AUTO] and set [LINK] to [GROUP A].
14) [APPLY] [BRIGHTNESS CONTROL
SETUP] of all projectors and press
<ENTER> button.
Brightness control will commence.
z
Note
z The brightness is corrected automatically each time the
lamps are turned on using the power switch etc.
z If the brightness fluctuates significantly or the lamp has
been replaced, re-adjust the brightness control.

STANDBY MODE

You can select the electrical consumption while in

standby mode.

1 ) Press ▲▼ to select [STANDBY MODE].
2 ) Press ◄► to switch [STANDBY
MODE].
The setting will change as follows each time
z
◄► is pressed.

NORMAL

Note
z With [ECO] setting, NETWORK function, RS-232C output
and some of RS-232C commands are not available.
When switch on the projector, projection will start about
10 seconds late.
82
- ENGLISH

SCHEDULE

This sets the command execution schedule for each
day of the week.
How to enable the SCHEDULE
J
function
1 ) Press ▲▼ to select [SCHEDULE].
2 ) Press ◄► to switch [SCHEDULE].
The setting will change as follows each time
z
◄► is pressed.
Note
z If [SCHEDULE] is set to [ON], the setting for [STANDBY
MODE] is automatically set to [NORMAL] and cannot be
changed. Even if [SCHEDULE] is then set to [OFF] when
in this state, the setting of [STANDBY MODE] remains at
[NORMAL].
How to assign a program
J
1 ) With [SCHEDULE] switched to [ON],
press <ENTER> button.
The [SCHEDULE] screen will be displayed.
z
2 ) Select and assign program to each day
of week.
Press ▲▼ to select a day of week and press
z
◄► to select a program number.
You can set the program from No.1 to No.7.
z
"- - -" indicates that the program number has
not been set yet.
How to set a program
J
You can set up to 16 commands to each program.
1 ) On the [SCHEDULE] screen, press ▲▼
ECO
to select [PROGRAM EDIT].
2 ) Press ◄► to select a program number
to be set and press <ENTER> button.
3 ) Press ▲▼ to select a command
number and press <ENTER> button.
You can change the page using ◄►.
z
ON

OFF