Projecting; Selecting The Input Signal; How To Adjust The Focus, Zoom And Shift - Panasonic PT-DW105XEA Operating Instructions (Functional Manual)

Projecting

Projecting
Check the connections of the peripheral devices, installation of the projection lens (
Æ
of the power cord (
and adjust the image.

Selecting the input signal

Select an input signal.
The image selected with <INPUT SELECT> button is
projected. ( Æ page 47)
Attention
z Images may not be projected properly depending on the
connected device and DVD, video tape, etc. to be played.
Select a system format that is suitable for the input signal
using the [SYSTEM SELECTOR] in the [PICTURE] menu
Æ
( page 58).
z Check the aspect ratios of the screen and the image and
select the optimum aspect ratio using [ASPECT] in the
[PICTURE] menu (
42
- ENGLISH
page 39) and switch on the power (
Æ
page 59).
Æ
page 40) to start the projector. Select the input signal
How to adjust the focus,
zoom and shift
Use the Lens Shift, Zoom, and Focus controls to
properly frame the image on the screen.
At the projector
J
1 ) Press <LENS> button on the control
panel.
Pressing the button changes the setup screen
z
in the order of [FOCUS], [ZOOM] and [SHIFT].
2 ) Press ▲▼◄► to select an item and
adjust it.
Using the remote control
J
1 ) Press <LENS> (FOCUS, ZOOM, SHIFT)
button on the remote control.
Press <FOCUS> button :
z
Adjust focus.
Press <ZOOM> button :
z
Adjust zoom.
Press <SHIFT> button :
z
Adjust focus.
2 ) Press ▲▼◄► to select an item and
adjust it.
Note
z Be careful not to catch your fingers between the lens and
shroud when shifting the lens.
z The zoom adjustment menu will be displayed only when
a lens with zoom function is installed.
z When using ET-D75LE5, set the shift to the home
position.
z The adjustment can be performed faster by pressing and
holding the ▲▼◄► for about 7 seconds or more.
z It is recommended that the images are projected
continuously for at least 30 minutes before the focus is
adjusted.
z If the power is turned off during focus or shift adjustment,
the LENS CALIBRATION must be performed when the
power is turned on next time.
z If the main power is turned off during focus adjustment,
the LENS CALIBRATION will be performed automatically
when the focus is adjusted next time.
z If the main power is turned off during shift adjustment,
"LENS CALIBRATION ERROR" is displayed when the
shift is adjusted next time. Please perform the [LENS
CALIBRATION] from the menu (
z If "LENS CALIBRATION ERROR" is still displayed after
the LENS CALIBRATION is performed, ask your dealer
for repair.
Æ
page 38), and connection
Æ page 86)