Menu Navigation; Navigating Through The Menu - Panasonic PT-DW105XEA Operating Instructions (Functional Manual)

Menu Navigation

Menu Navigation
Menus are extensively used for configuring, adjusting or reconfiguring the projector.

Navigating through the menu

Operating procedure
J
1 ) Press <MENU> button.
[MAIN MENU] appears on the screen.
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
PROJECTOR SETUP
P IN P
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
SUB MENU
ENTER
2 ) Press ▲▼ to select the desired item.
The selected item is highlighted in orange.
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
PROJECTOR SETUP
P IN P
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
SUB MENU
ENTER
3 ) Press <ENTER> button to establish
your selection.
The submenu for the selected option will now
open.
POSITION
SHIFT
ASPECT
ZOOM
CLOCK PHASE
GEOMETRY
MENU SELECT
SUB MENU
ENTER
50
- ENGLISH
DEFAULT
0
OFF
4 ) Press ▲▼ button to highlight the
desired adjustment item, then press
◄► to change or adjust the parameter
value.
For some items, an individual adjustment screen
containing a bar scale will appear as shown in the
diagram below when ◄► is pressed.
CONTRAST
ADJUST
Note
z Press <MENU> button to return to the previous menu.
z Some menu items may not be valid for certain signal
formats applied to the projector. The menu items that
cannot be adjusted or used are shown in gray characters,
and they cannot be selected.
z If no button is pressed for approx. 5 seconds while the
individual adjustment screen is displayed, the screen will
return to the previous page.
Resetting to the factory default
J
If an adjustment item is selected and <DEFAULT>
button is pressed, the adjustment value will return
to the factory default setting.
Press
CONTRAST
ADJUST
Note
z You cannot reset all the settings at a time to the factory
default settings. To reset all the settings to the factory
defaults, refer to "INITIALIZE" of "PROJECTOR SETUP
Æ
menu" ( 87 page).
z Some menu items are not available to reset by pressing
<DEFAULT> button. Adjust each menu item manually.
z The triangle mark under the bar indicates factory default
setting and the square indicates the current setting.
The triangle mark position varies by the selected input
signals.
Current setting
Default setting
0
0