Troubleshooting - Panduit CP-881/E Operation Manual

© Panduit Corp. 2013

TROUBLESHOOTING

Fault Condition 1:
Cable cannot be inserted
o Cable can only be inserted in start
position (front) and not in
maintenance position (rear).
o Press the reverse button (1) to
move the CP-881/E into start
position.
Fault Condition 2:
Crimping has not been completed.
Disconnect the main power
supply from the CP-881/E and
open cover.
1. Stop operation
o Read counter (1) if required.
o Turn OFF (Position O) the
CP-881/E with main switch (2).
o Disconnect main cable (3).
PA27004A01_03 ENG
OPERATION MANUAL
Diagram 19: Move the CP-881/E into start position
Page: 19 of 28
Diagram 20: Stop operation
CP-881/E ENG
10-2013