Retooling - Panduit CP-881/E Operation Manual

© Panduit Corp. 2013

RETOOLING

1. Prepare the retooling
Disconnect the main power
supply from the CP-881/E and
open cover.
o Read counter if required.
o Turn OFF the CP-881/E with main
switch (1).
o Disconnect main cable (2).
o Slide back the cover (3).
o Pull the pin (4) upwards and pull
out the ferrules (5).
o Remove the dispenser (6) and roll
up the remaining ferrules.
o Fold back the dispenser holder (7).
2. Remove the tool insert
o Pull out the bolt (1).
o The tool insert (2) must be
removed sideways.
o Put the tool insert into the tool kit.
o Check crimp die for talcum powder
build-up.

If powder build-up, clean with
brush.
PA27004A01_03 ENG
OPERATION MANUAL
Diagram 16: Prepare the retooling
Page: 17 of 28
Diagram 17: Remove tool insert
CP-881/E ENG
10-2013