Emerson SolaHD S4K2U-5C Series User Manual page 19

5. Extend the bracket assembly by sliding the front member forward until it touches the rack's front vertical rails (adjust-
able length: 457–813 mm/18–32 in.). Use two m5 screws to fix each front member onto the front vertical rails through
the installation holes. make sure that bracket assemblies are at the same mounting height on all four rack rails, as
shown in Figure 10.
M5 Screw
(4 pcs)
Figure 10: Installing front member of each bracket assembly
6. Fasten rear member and front member together using four m4 screws and four m4 nuts (m4 nuts have been installed
on the rear member before delivery) per bracket assembly as shown in Figure 11.
Figure 11: Fastening rear member and front member together
Front
Vertical
Pole Slide
Front
Member
Front member
S4K2U-5C SEriES USEr mAnUAL | 19
Rear
Member
Rear Member
M4 Screw (8 pcs)
M4 Nut (8 pcs)