DAPAudio Core Mix-2 USB Manual page 16

Fig. 15
46. Master XLR balanced out
Use these outputs to connect an amplifier with balanced inputs.
47. GND screw
To connect the ground wire of your turntable.
48. USB 2 input
To connect to a PC/Mac with DJ software.
49. USB/MP3 level control
Use to adjust the level for the USB inputs.
50. USB 1 input
To connect to a PC/Mac with DJ software.
51. Mic input
Electronically balanced XLR-type input for connecting low impedance microphones. The input has
extremely low noise hum. When connecting a microphone make sure that the pin assignment is correct.
Always make sure to read the manual of the microphone you want to connect. The XLR- input is not
suitable for connecting an additional mixing console, FX- unit, etc. You have to use the LINE-inputs, when
connecting this kind of equipment.
Note: When connecting signal sources, please make sure that the corresponding Channel's level control
and the master faders are at their minimum settings. Otherwise, unpleasant plug-in noise can occur.
15