Integrating With A Model 3706A-S Using Tsp-Link; Introduction; Equipment Required - Tektronix Keithley DMM7512 Applications Manual

Integrating with a Model 3706A-S using TSP-Link

In this section:

Introduction .............................................................................. 6-1

Equipment required .................................................................. 6-1

Device connections .................................................................. 6-2
Integrating with a Model 3706A-S test setup ............................ 6-4
Introduction
This application example demonstrates how to configure the DMM7510 and Model 3706A-S System
Switch to interact through TSP-Link
channels in multiple slots of a Model 3706A-S.
This is a common production test setup that monitors a variety of signals. These signals are typically
routed through a switch that can accommodate the performance and throughput of the test
requirement.
The example includes:
•
30 channels that measure dc voltage in slot 1 at two different ranges
•
10 channels that measure ac voltage in slot 1
•
20 channels that measure 4-wire resistance in slot 4
Equipment required
This application requires the following equipment:
•
One DMM7510
•
One Model 3706A-S Six-Slot System Switch
•
One Model 3721 Dual 1 × 20 Channel Multiplexer Card and Model 3721-ST Screw
Terminal Block
•
One Model 3724 Dual 1 × FET Multiplexer Card and Model 3724-ST Screw Terminal Block
•
Multiple devices or components to be tested
•
Several insulated cables with banana plugs
•
One computer set up for communication with the DMM7510
®
. The application measures different types of signals on multiple
Section 6