Using Tsp Commands - Tektronix Keithley DMM7512 Applications Manual

Section 5: Grading and binning resistors Model DMM7510 7½ Digit Multimeter Application Manual

Using TSP commands

The following TSP code is designed to be run from Keithley Instruments Test Script Builder (TSB).
TSB is a software tool that is available from tek.com/keithley. You can install and use TSB to write
code and develop scripts for TSP-enabled instruments. Information about how to use TSB is in the
online help for TSB and in the "Introduction to TSP operation" section of the Model DMM7510
Reference Manual.
To use other programming environments, you may need to make changes to the example TSP code.
By default, the DMM7510 uses the SCPI command set. You must select the TSP command set
before sending TSP commands to the instrument.
To enable TSP commands:
1. Press the MENU key.
2. Under System, select Settings.
3. Set the Command Set to TSP.
4. At the prompt to reboot, select Yes.
This sequence of TSP commands grades resistors into established bins of accuracy. After the code
executes, the data is displayed in the Instrument Console of Test Script Builder.
5-6 DMM7510-904-01 Rev. D March 2021