Table of Contents
Advertisement
Problem
Arc splutters/flares
Torch parts wear quickly
Circuit breaker/fuse trips
while operating
28
Cause
Worn torch parts
Water in the air supply
Wet or dirty air supply
Exceeding unit capability
Excessive ignition Arc use
Inadequate air supply, pressure
too low
Faulty air compressor
Extension cord being used is not
heavy duty
Extension cord being used is too
long
Cutting beyond the duty cycle
capacity of the machine
© Weldclass 2020 | E.&O.E.
Solution
Replace with new torch parts
Install air drier or additional
filtration.
Drain compressor and air lines.
Install air drier or additional
filtration.
Drain compressor and air lines.
If material too thick, increase
angle to prevent blow back into
torch tip
Do not operate ignition arc for
more than 3 seconds – ideally
start in contact with edge of
material.
Do not start ignition arc in mid-air.
Check air filters, increase air
pressure
Check air compressor operation
and make sure supplied air
pressure is at least 90psi.
Use a heavy duty extension cord
2
(2.5mm
)
Remove extension cord or use
shorter one.
Turn the amperage down or do
shorter cutting runs
.
Advertisement
Table of Contents
