Table of Contents
Advertisement
Cleaning of the device is important to assuring optimal performance and longevity.
Minimize the use of alkaline or acidic cleaners, as they may cause pitting and dulling of the finish.
1. Remove the pin on the push assembly, move the
handle out of the way, and lift the push assembly off
the guide rods.
2. Remove the blade assemblies off the pins, one at a
time from the base.
WARNING: THE BLADES ARE VERY SHARP.
PLEASE USE CAUTION WHEN HANDLING
Note: The blade assemblies can also be removed
when the push assembly is locked in the up
position.
3. Thoroughly wash/rinse/sanitize parts in warms soapy
water, dry and carefully reassemble.
Note: Hand washing unit is recommended as
washing in a commercial dishwasher will cause
the all aluminum parts to darken over time, this is
normal, and does not effect the general operation
of the unit.
Note: Either blade assembly can be placed on the
bottom or top.
As needed, lubricate the guide rods with mineral oil, food grade grease, or rub them with Paraffin.
Do not lubricate with cooking oil.
6
CLEANING
MAINTENANCE
Config. 1 - in use
Config. 2 - locked
Advertisement
Table of Contents
