Winco KATTEX OS-188 Quick Start Manual page 4

Since the push assembly and blade block assemblies for different sized cuts are interchangeable, you
may have more than one set available for use. Before slicing, please ensure that the push assembly is the
correct one to use for the desired cut size. Gently lower the push assembly onto the blade block assembly
to ensure that the push assembly rests on the bumpers. If it does not, adjustments need to be made prior
to beginning the chopping procedure.
1. Remove the cable ties.
2. Remove locking pin from the push assembly. Slide the push
assembly and PVC pipes off the guiding rods. Discard the PVC
pipes.
3. Using the wrench provided, remove the hex bolt, lock washer,
and washer from the base. Using the wrench provided,
attach the leg to the base with the hex bolt, lock washer, and
washer. Repeat process for the remaining legs.
Note: There are left and right legs.
4. Slide the push assembly back on the guide rods. Attach the
handle with the locking pins.
Note: Configuration 1 is for in use and Configuration 2 is for
locking the handle and push assembly in up position.
4
PREPARATION
Config. 1 - in use Config. 2 - locked