Table of Contents
Advertisement
Connecting Leaf Switches to Spine Switches
• For a VIC 1455 SFP28 module, 10-Gigabit only, use one of the following sets of transceivers and cables:
• Cisco 10GBASE-LR transceivers (SFP-10G-LR) supporting a link length of up to 6.1 miles (10 km)
• Cisco 10GBASE-SR transceivers (SFP-10G-SR) supporting the following link lengths:
• Using 2000 MHz MMF (OM3) for up to 984 feet (300 m)
• Using 4700 MHz MMF (OM4) for up to 1312 feet (400 m)
• Cisco SFP+ Active Optical Cables (SFP-10G-AOCxM [where x=1, 2, 3, 5, 7, or 10 for lengths in meters])
• Cisco SFP+ Twinax Cables (SFP-H10GB-CUxM [where x=1, 2, 3, 5, 7, or 10 for lengths in meters])
To determine which transceivers, adapters, and cables are supported by this switch, see
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
To see the transceiver specifications and installation information, see
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-installation-guides-list.html.
Step 2
Connect the other end of the interface cable to a downlink port on a leaf switch.
• For a Cisco 10GBASE-LR or -SR transceiver and cable, insert the transceiver into a downlink optical port on a leaf
switch before connecting the cable to the transceiver.
• For Cisco SFP+ Active Optical Cables, insert the transceiver on the cable into a downlink optical port on a leaf
switch.
• For a 10GBASE-T copper cable, insert the RJ-45 connector on the cable into a downlink BASE-T port on a leaf
switch.
To determine which transceivers and cables are supported by this switch, see
Note
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
Connecting Leaf Switches to Spine Switches
For optimal forwarding between endpoints, you must connect each leaf switch to every spine switch in the
same ACI fabric.
To determine which transceivers, adapters, and cables are supported by this switch, see
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
To see the transceiver specifications and installation information, see
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-installation-guides-list.html.
Warning
Statement 1055 Class I and Class 1M Laser
Class 1/1M laser product.
Cisco Nexus 93128TX ACI-Mode Switch Hardware Installation Guide
32
Connecting the Switch to the ACI Fabric
Advertisement
Table of Contents
