Table of Contents
Advertisement
Overview
5
96 10GBASE-T copper ports (supporting
100-Megabit, 1-Gigabit, and 10-Gigabit Ethernet)
to Application Policy Infrastructure Controllers
(APICs)
To determine which transceivers, adapters, and cables are supported by this switch, see the
Modules Compatibility Information
The following figure shows the hardware features seen from the fan side of the chassis.
1
Screw holes (2) for attaching the grounding lug.
2
A notch in both sides of the chassis for locking
the fan side of the chassis to the bottom-support
rails.
3
Two power supply modules (one used for
operations and one used for redundancy) (AC
power supplies shown) with slots numbered 1
(left side) and 2 (right side).
4
Three fan modules (two used for operations and
one used for redundancy) with slots numbered
from 1 (left side) to 3 (right side)
Depending on whether you plan to position the ports in a hot or cold aisle, you can order the fan and power
supply modules with port-side intake or port-side exhaust airflow. For port-side intake airflow, the fan modules
have burgundy coloring (DC power supply modules have green coloring). For port-side exhaust airflow, the
fan modules have blue coloring (DC power supply modules have gray coloring).
The fan and power supply modules are field replaceable and you can replace one fan module or one power
supply module during operations so long as the other modules are installed and operating. If you have only
10
Screw holes (2) for attaching a front-mount
bracket for 4-post racks (1 bracket on each of 2
sides)
document.
5
Chassis LEDs include the following:
• Beacon (BCN)
• Status (STS)
6
Screw holes (4) for attaching a center-mount rack
bracket for 2-post racks (1 bracket for each of 2
sides).
7
Screw holes (2) for attaching a front-mount
bracket for 4-post racks (1 bracket on each of 2
sides).
Cisco Nexus 93128TX ACI-Mode Switch Hardware Installation Guide
Overview
Cisco Transceiver
3
Advertisement
Table of Contents
