Installing Memory - Supermicro Supero H8SME-F User Manual

H8SME-F SERVERBOARD USER'S MANUAL
2-5

Installing Memory

Warning: Exercise extreme caution when installing or removing memory modules to
prevent any possible damage.
Installing Memory
1. Insert each memory module vertically into its slot, paying attention to the
notch along the bottom of the module to prevent inserting the module
incorrectly (see Figure 2-1).
2. Install to slots DIMM1A, DIMM2A, etc. Always install in groups of two and in
the numerical order of the DIMM slots. See support information below.
3. Gently press down on the memory module until it snaps into place.
Note: 1 GB, 2 GB, 4 GB or 8 GB size memory modules are supported. It is highly
recommended that you remove the power cord from the system before installing or
changing memory modules. Please refer to our web site for memory that has been
tested on the H8SME-F motherboard.
Support
T h e H 8 S M E - F
DDR3-1600/1333/1066 Mhz speed very low profi le (VLP) unbuffered ECC/non-
ECC SDRAM memory.
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
Maximum memory for the H8SME-F motherboard is up to 32 GB of DDR3 very low
profi le (VLP) unbuffered ECC SDRAM in four (4) slots.
m o t h e r b o a r d s u p p o r t s
2-10
s i n g l e / d u a l c h a n n e l ,