Table of Contents
Advertisement
installation
interface cable connectors
can connector
This is the CAN communication bus connector. The cable from this
connector is tied to the CNC/process controller.
J1 (ras)
This is a connector for interfacing with Remote Arc Starter (RAS)
unit. The cable from this connector carries signals such as: Mark
Mode and Hi-Frequency ON.
analog interface connector
This connector is used when the plasma unit is used in analog com-
munication mode where the CAN communication is not available.
A junction box is used to connect customer CNC/process controller
to the plasma unit. A shielded DB25-DB25 cable, as mentioned in
section 3.8.3, connects the analog interface connector to the junc-
tion box.
Interface Cable Connectors Panel (bottom side of front panel)
Analog
Interface
CAN
J1 (RAS)
38
Advertisement
Table of Contents
