Table of Contents
Advertisement
installation
general
Warning
unpacking
•
Inspect for transit damage immediately upon receipt.
•
Remove all components from shipping container and check for loose parts in container.
•
Inspect louvers for air obstructions.
placement
•
A minimum of 1 meter (3 ft.) clearance on front and back for cooling air flow.
•
Plan for top panel and side panels having to be removed for maintenance, cleaning and inspection.
•
Locate the plasma unit relatively close to a properly fused electrical power supply.
•
Keep area beneath power source clear for cooling air flow.
•
Environment should be relatively free of dust, fumes and excessive heat. These factors will affect
cooling efficiency.
caution
installation
failure to folloW instructions coulD leaD to Death, in-
JurY or DamageD propertY. folloW these instructions
to preVent inJurY or propertY Damage. You must com-
plY With local, state anD national electrical anD safetY
coDes.
conductive dust and dirt inside power source may cause arc flash-
over. equipment damage may occur. electrical shorting may occur if
dust is allowed to build-up inside power source.
see maintenance section.
27
Advertisement
Table of Contents
