Installation Requirements; Electrical; Gas; Electrical Connection - Bertazzoni MAST244GASXE Installation Manual

Freestanding full gas ranges
Hide thumbs Also See for MAST244GASXE:
Table of Contents

Advertisement

/ Installation requirements / Electrical connection

INSTALLATION REQUIREMENTS

ELECTRICAL

A properly-grounded horizontally- mounted electri-
cal receptacle should be installed no higher than
3" (7.6 cm) above the fl oor, no less than 2" (5 cm)
and no more than 8" (20,3 cm) from the left side
(facing product).
Check all local code requirements.

GAS

An agency-approved, properly-sized manual
shut-off valve should be installed no higher than
3" (7.6 cm) above the fl oor and no less than 2" (5
cm) and no more than 8" (20.3 cm) from the right
side (facing product).
To connect gas between shut-off valve and regula-
tor, use agency-approved, properly sized fl exible
or rigid pipe. Check all local code requirements.
installation area for the connection
10

ELECTRICAL CONNECTION

Warning!
ELECTRICAL SHOCK HAZARD
Disconnect electrical power at the circuit bre-
aker box or fuse box before installing the ap-
pliance.
Provide appropriate ground for the appliance.
Use copper conductors only.
Failure to follow these instructions could re-
sult in serious injury or death.
This unit is manufactured for a polarized, groun-
ded 120 volt/60 Hz, 16 amp system.
Electric power consumption is about 2.5A.
The minimum of 102 VAC is required for proper
operation of gas ignition systems.
The circuit must be grounded and properly pola-
rized.
The unit is equipped with a SJT power cord and
a NEMA 5-15P plug. In case of replacement, the
power cord shall be replaced with one of the same
type, size and length.
Warning!
Electrical grounding
This appliance is equipped with a three-prong
plug for your protection against shock hazard and
should be plugged directly into a properly groun-
ded socket. Do not cut or remove the grounding
prong from this plug.
Caution
Label all wires prior to disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
Verify proper operation after servicing.

Advertisement

Table of Contents
loading

Table of Contents