Southbend G Series Owner's Manual page 36

T
ROUBLESHOOTING
BLOWER WHEEL REPLACEMENT
To replace the blower wheel, do the following:
1. Remove racks and rack guides.
2. Remove rear air baffle in front of blower wheel.
3. Loosen the two square heads on blower wheel hub.
4. Pull blower wheel from motor shaft. If blower wheel is difficult to pull off, use puller
disk (available from Southbend as part number 1179100).
WIRING DIAGRAMS
A wiring diagram is located on the side of the control panel assembly (as shown on page 35). Wiring diagrams also
appear on the following pages of this manual. Which wiring diagram is appropriate depends on the voltage and type of
controls.
Index of Wiring Diagrams
Page Number Voltage and Type of Controls
37 208-240 Volt Models with Standard Controls
38 480 Volt Models with Standard Controls
39 415/240 Volt Models with Standard Controls
40 380/220 Volt Models with Standard Controls
41 208-240 Volt Models with Cycle/Cook & Hold Controls
42 480 Volt Models with Cycle/Cook & Hold Controls
43 415/240 Volt Models with Cycle/Cook & Hold Controls
44 380/220 Volt Models with Cycle/Cook & Hold Controls
PAGE 36 OF 48
OPERATOR'S MANUAL 1181958 REV 6 (11/15)
E C
LECTRIC ONVECTION
O
VENS