Electrolux EOB93434AW User Manual page 28

28 www.electrolux.com
Problem
The oven does not heat
up.
The lamp does not oper‐
ate.
Steam and condensation
settle on the food and in
the cavity of the oven.
There is no good cooking
performance using the
function: True Fan Cooking
PLUS.
There is no good cooking
performance using the
function: True Fan Cooking
PLUS.
There is no good cooking
performance using the
function: True Fan Cooking
PLUS.
You want to activate the
True Fan Cooking function,
but the indicator of the
Plus Steam button is on.
The water in the cavity em‐
bossment does not boil.
The water comes out of
the cavity embossment.
The display shows "12.00". There was a power cut.
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
Possible cause
The fuse is blown.
The lamp is defective.
You left the dish in the
oven for too long.
You did not turn on the
function: True Fan Cooking
PLUS.
You did not turn on cor‐
rectly the function: True
Fan Cooking PLUSwith the
Plus Steam button.
You did not fill the cavity
embossment with water.
The True Fan Cooking
PLUS function operates.
The temperature is too low. Set the temperature at
There is too much water in
the cavity embossment.
The necessary data for the service
centre is on the rating plate. The rating
plate is on the front frame of the oven
cavity. Do not remove the rating plate
from the oven cavity.
Remedy
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Refer to "Activating the
function: True Fan Cooking
PLUS".
Refer to "Activating the
function: True Fan Cooking
PLUS".
Refer to "Activating the
function: True Fan Cooking
PLUS".
Push the Plus Steam but‐
ton to stop the True
Fan Cooking PLUS func‐
tion.
least to 110 °C.
Refer to "Hints and tips"
chapter.
Deactivate the oven and
make sure that the appli‐
ance is cold. Wipe the wa‐
ter with a cloth or sponge.
Add the correct amount of
water to the cavity em‐
bossment. Refer to the
specific procedure.
Reset the clock.