Table of Contents
Advertisement
Dakota Ultrasonics
The numeric portion of the display consists of 4 complete digits
preceded by a leading "1", and is used to display numeric values, as well
as occasional simple words, to indicate the status of various settings.
When the DX-1 is displaying thickness measurements, the display will hold
the last value measured, until a new measurement is made. Additionally,
when the battery voltage is low, the entire display will begin to flash. When
this occurs, the batteries should be replaced.
These eight vertical bars form the Stability Indicator. When the DX-1 is
idle, only the left-most bar and the underline will be on. When the gauge is
making a measurement, six or seven of the bars should be on. If fewer
than five bars are on, the DX-1 is having difficulty achieving a stable
measurement, and the thickness value displayed will most likely be
erroneous.
6
The Display
Advertisement
Table of Contents
