Auto Scan - DAVIS Weather Monitor II Owner's Manual

Using the Console Functions
To Use Total Clear
1. Display any function except highs or lows, alarms, or daily accumulated rainfall.
2. Press CLEAR and hold it down.
The unit will beep and the display will flash seven times and then stop. When
this happens, the functions listed above have been cleared.
A S
UTO CAN
The Weather Monitor II can be set to perform an automatic scan of the weather
functions. Each reading appears on the display (in the unit of measure you last
used) for approximately four seconds before being replaced by the next func-
tion in the scan routine. There is a pre-programmed scan routine which
reviews weather functions in the order given below.
• Current, High, and Low Inside Temperature
• Current, High, and Low Outside Temperature
• Current and High Wind Speed
• Current Wind Direction
• Current and Low Wind Chill
• Daily and Accumulated Rainfall
• Current and Stored Barometric Pressure
• Current, High, and Low Inside Humidity
• Current, High, and Low Outside Humidity
• Current, High, and Low Dew Point
You may also program a customized scan routine to review only the functions
you desire. The console can store one customized scan routine in addition to
the pre-programmed scan.
Note: You can enter time and/or date into the customized scan routine, though they are not included in the
pre-programmed scan routine.
To Start and Stop a Scan Routine
1. Press SCAN. The pre-programmed scan routine begins.
2. To begin the customized scan routine (if you have entered one), press SCAN again.
3. To stop the scan routine, press any key except SCAN or ENTER.
Page 34 Weather Monitor II