Loading Discs - Epson Disc Producer PP-100NII User Manual

Loading discs

Follow the steps below to load discs in the stacker and insert it.
Load the discs in a stacker. Do not load discs in the drives or printer. Furthermore, do not load
discs between Drive 1 and Drive 2. They may become unable to be taken out.
Fully separate the discs to prevent them from sticking together.
1
• Be sufficiently careful not to scratch a disc.
• If a long time elapses after discs are loaded in the stacker, the separated discs may stick
together again. Fan the discs again if a long time has elapsed since they were loaded.
Take out the input stacker and load the discs into it.
2
Do not replenish or remove discs while the stacker is attached to this product. Be sure to
remove the stacker beforehand.
The stacker to use as the input stacker differs depending on the set Publish Mode. Confirm the input stacker
in the following table.
Publish Mode
Standard Mode
External Output Mode
(Different types of discs can be loaded into Stacker 1 and
Stacker 2.)
Batch Mode
Place the label surface facing upwards.
Input
Number of Discs
Stacker
Stacker 1 Up to approximately 50 discs
Stacker 1 Up to approximately 50 discs
Stacker 2 Up to approximately 50 discs
Stacker 1 Up to approximately 50 discs
Stacker 2 Up to approximately 50 discs
Publishing Discs
90