Epson Disc Producer PP-100NII User Manual page 177

Error Message
Stacker 4 full
Stacker 4 open
Stacker full
ST2,ST3,ST4
Too many discs
ST1,ST2,ST3
Transferred disc
detection error
Wait a moment
and try again
Write error
Remedy
The initialization operation cannot be performed because
Stacker 4 is full.
Remove the discs from Stacker 4.
Close Stacker 4.
The disc cannot be ejected because the output stacker is full.
Remove the discs from the output stacker (Stacker 2,
Stacker 3, or Stacker 4).
Remove excess discs so that the height of the discs in the
indicated stacker is below the dotted red line of the stacker,
and then close the disc cover.
A disc could not be detected after transfer to a printer or drive.
Turn off the power, and then turn it on again. If the same
error message still appears, repair is required. Please contact
Customer Support.
Press the button or CANCEL button. Do not unlock the
disc cover repeatedly within a short time. Wait a moment before
unlocking.
Processing of the job is paused. See "Disc writing problems"
on page 180 in this guide, and after removing the cause of
the error, restart the job. (See "Resuming jobs" on page 117 in
this guide for the job restarting procedure.)
Troubleshooting
Notification
Sound
177