Loading Discs - Epson DiscProducer PP-100N User Manual

Loading discs

This section describes how to load discs in the stacker, and insert the stacker.
Load the discs in a stacker. Do not load discs in the drives or printer. Furthermore, do not
load discs between Drive 1 and Drive 2. They may become unable to be taken out.
1
Fully separate the discs to prevent them from sticking together.
• Be sufficiently careful not to scratch a disc.
• If a long time elapses after discs are loaded in the stacker, the separated discs may
stick together again. Fan the discs again if a long time has elapsed since they were
loaded.
2
Take out the input stacker and load the discs into it.
Do not replenish or remove discs while the stacker is attached to this product. Be sure to
remove the stacker beforehand.
The stacker to use as the input stacker differs depending on the set Publish Mode. Confirm the input stacker in
the following table.
Standard Mode
External Output Mode
(Different types of discs can be loaded into Stacker 1
and Stacker 2.)
Batch Mode
Publish Mode
Place the label surface facing upwards.
Input Stacker Number of Discs
Stacker 1 Up to approximately 50 discs
Stacker 1 Up to approximately 50 discs
Stacker 2 Up to approximately 50 discs
Stacker 1 Up to approximately 50 discs
Stacker 2 Up to approximately 50 discs
Publishing Discs
83