Advertisement
Electronic pellet burner controller – NPBC-V3C-K / NPBC-V4C-K / NPBC-V4E-K
No Exec module
Power On
Power Off
Begin
Automatic warning messages
In case of incorrect parameter input or if a change in the current menu caused changes in some of
the parameters from a different menu, the controller displays warning messages. For example:
Parameter settings
NPBC-V3C / NPBC-V4C has two main groups of parameters with an option for a different access
level to them: User settings and Factory settings. Press the Menu button once to enter the User
settings. They are available for any user at any time. Press and hold the Menu button for more than
2 seconds to enter the Factory settings. If the option for an access code has been activated, only
users who know it can access the Factory settings.
The controller has different types of menus. The examples below explain these types and the way to
set the parameters in each of them. Regardless the menu type, if no buttons are pressed for certain
time, the controller goes back to the previous screen or to the main screen. After adjusting the
parameters according to your needs, press the Menu button (
List choice – A red bar indicates the currently selected row. Press the up or down navigation
•
▲ or ▼)
buttons (
to move the bar and the right navigation button (►) to confirm the
selection. An arrow pointing down at the bottom of the screen or up on the top of the screen
indicates that there are more options in the corresponding direction outside of the visible area
of the screen. In this case, press the corresponding navigation button to go to the next or the
previous page. If there is an arrow pointing right on any of the rows on the screen, there is a
User Manual / ver3.8
---
No connection with the Executive module
---
Date and time when the power supply to the
controller was turned on
---
Date and time when the power supply to the
controller was turned off
---
Date and time when the controller's software or the
information in the Diagnostics screen has been reset
) to save your settings.:
Page 3 of 33
Advertisement
