Sena SP56 Manual page 3

15. Listening to Preset Stations
Tap the Phone Button once to go upward to your next saved preset station.
16. Saving or Deleting Stations
1. To save the current station, press and hold the Jog Dial for 2 seconds until you hear a voice prompt,
"Preset (#)".
2. Rotate the Jog Dial clockwise or counter clockwise, in order to select which preset number you want for
that specific station.
3. To save the current station, tap the Jog Dial again. You will then hear a voice prompt, "Save preset (#)".
4. To delete the saved station in the preset number, tap the Phone Button. You will then hear a voice prompt
"Delete preset (#)".
17-1. Settings
<Headset Settings>
To enter into voice configuration menu, press and hold the Jog Dial for 10 seconds until the LED shows
solid blue and you hear high toned double beeps.
<Camera Settings>
To enter into camera configuration menu, press and hold the Camera Button for 8 seconds until you hear
a voice prompt, "Camera setup".
18. Factory Reset
If you want to restore the 10C to factory default settings, press and hold the Phone Button for 10 seconds.
Tap the Jog Dial. The headset automatically restores the default settings and turns off.
19. Fault Reset
If the 10C is not working properly for any reason, push the pin-hole reset button located on the back of the
headset.