Phone: (800) 793-0093 (U.S.A. and Canada) Monday — Friday 6:00 . to 5:00 Web site: www.Dacor.com All specifications are subject to change without notice. Dacor assumes no liability for changes to specifications. Table of Contents Installation Instructions ... 6 Verify the Package Contents ... 6 Electrical Connection ...
A qualified technician must complete the installation of this built-in appliance. The owner is responsible to make sure the dishwasher is properly installed. Improper connection of the electrical wiring may create an electric shock or fire hazard and may result in damage to the dishwasher’s electrical system. Do not use the dishwasher until it is completely installed.
The customer should not install, repair or replace any part of the dishwasher unless specifically recommended in the literature accompanying it. A qualified service technician should perform all other service. Contact the nearest Dacor authorized service representative for examination, repair or adjustment. •...
Installation Specifications Product Dimensions Product tolerances: ±1/16” (±1.6 mm), -0, unless otherwise stated 23 7/8" (606 mm) adjustible to 24 1/4" (616 mm) 3 1/4" (83 mm) from side to water inlet Handle style varies with model number. WARNING Electric Shock Hazard: Observe all governing codes and ordinances during planning and installation, including all plumbing and electrical work.
Verify the Package Contents • Cut the shipping carton open and use it as a pad beneath the dishwasher until the legs are installed. With the assistance of at least one person, place the unit to the side of the cabinet opening.
Installation Instructions Electrical Connection WARNING • Do not install the dishwasher unless the electrical service provided meets the dishwasher specifications (see page 4). • To avoid an electrical shock hazard, turn off power to the junction box at the circuit breaker panel or fuse box before proceeding.
Do not remove the rear insulation blanket. With the help of at least one other person, lay the dishwasher on its back. Do not kink or crush the drain hose. Install the leveling legs into the holes below the red (shipping) plugs.
1/4” clearance at the top. Open the door and remove the bottom rack. Check that the dishwasher is level from front to back by placing a level inside, on the bottom of the tub. Check to make sure the dishwasher is level side to side by placing the level on the top front of the tub.
• Be careful not to pinch the wiring, hot water line and drain hose as you push the dishwasher into place. An electric shock hazard or water damage may result from pinched wires or hoses. Damage due to improper installation is not covered under the warranty.
• Proper installation is the responsibility of the homeowner. The importance of proper installation of your Dacor dishwasher cannot be overemphasized. Pre-verification Check List □ Confirm that the main power supply (at the circuit breaker panel or fuse box) is off.
If you need service, be sure to have the model and serial numbers available when you call. See the inside cover for location. Dacor is not responsible for the cost of correcting problems caused by a faulty installation. Attaching the Unit to the Countertop Determine if the dishwasher can be attached to the countertop.
Adjustment screws Adjusting the Stainless Steel Trim Plates Your Dacor dishwasher has been equipped with adjustable stainless steel side trim plates. Each side can be adjusted independently to create a clean, integrated look with your cabinets.