® qualified installer. Department at 800.793.0093 or email customerservice@dacor. com. You can also visit our website at www.dacor.com. Before you begin the installation process, it is recommended that you read this entire Installation Instruction Manual. There are key details that you should take special care to observe during the installation.
ESIGN PECIFICATIONS RODUCT IMENSIONS Make sure the area selected for the installation site meets product dimension requirements. FIG 1 NSTALLATION PECIFICATIONS ATERIALS NOT INCLUDED BUT OOLS NOT INCLUDED BUT EEDED EEDED FOR NSTALLATIONS NSTALLATIONS • 90° elbow (3/8” NPT external thread on one end, opposite •...
NSTALLATION PECIFICATIONS NSTALLATION 90º 90º Electrical, water, and Please read all safety instructions before installing your new 34 1/4” min drain lines dishwasher. must be confined to 24” min 18” shaded area 4” WARNING WARNING – Electric Shock Hazard: Disconnect electrical 7 1/2”...
NSTALLATION PECIFICATIONS Review dimensions in Figure 3 to locate the dishwasher’s AKING THE ATER ONNECTION drain, water and electrical connections. All connections must be made in the shaded area of Figure 2, page 3 CAUTION CAUTION– Property Damage: Do not use the furnished drain hose or a rubber garden hose for the water supply line.
NSTALL PECIFICATIONS Air Gap AKING THE RAIN ONNECTION CAUTION CAUTION– To prevent siphoning, an air gap MUST BE USED when waste tee or disposer connection is less than 18” above the floor to prevent siphoning. Failure to provide the proper Right Side drain connection using an air gap or a 30”...
NSTALLATION NSTRUCTIONS EMOVING THE ACKAGING EMOVING THE OTOR UPPORT Cut the shipping carton and use it as a pad beneath the dishwasher. This will protect the finished floor in the kitchen. Locate the wedge of polystyrene (foam) from between the Remove wrapping and uncoil the drain hose in the back of motor and the liner.
NSTALLATION NSTRUCTIONS NOTE: NSTALLING THE LBOW Before continuing the installation, make sure you have an adequate surface to mount beneath or on the sides of Locate the water inlet valve. The valve has a 3/8” NPT the countertop and cabinets. Additional support may be female fitting.
NSTALLATION NSTRUCTIONS INISHING THE RAIN ONNECTION Verify that the power is turned off at NOTE: the source. Follow all local codes and ordinances. Strip the necessary insulation off the wires in order to make a good When connecting the drain line to the disposer, check connection.
NSTALLATION NSTRUCTIONS ECURING TO ABINET AND OUNTERTOP Countertop Material To maintain position and alignment, it is recommended to secure the dishwasher to the countertop and adjacent cabinets. exists: FIG 17 Wood Support If mounting the dishwasher to the countertop, check at a depth of 2.5”...
TAINLESS TEEL LATES Loosen depth adjustment screws. Slide bracket out to proper depth and tighten screws. See Your Dacor dishwasher has been equipped with adjustable Figure 21. ® stainless steel side trim plates. Each side can be adjusted Attach supplied toekick to brackets with provided color independently to create a clean, integrated look with your matched screws.
If you need service, be sure to have the model and serial numbers when you call. You’ll find these numbers on the serial number plate located on the light shield in the fresh food compartment. Contact a Dacor authorized Servicer, a Dacor dealer, or the ® ® Dacor Customer Service Department at 800.793.0093 or email...
Page 16
Specifications contained within are subject to change without notice. No liability is assumed by DACOR for changes in specifications. ® The information and images in this book are the copyright property of Distinctive Appliances, Inc. Neither this book nor any...