Listening To Radio; Phono Operation - boytone TR-18CD Operating Instructions Manual

NOTE: All the buttons on the remote control just use for CD/USB/SD function.
OPERATING INSTRUCTIONS

Listening to radio

1. Turn the volume knob in a clockwise direction to turn the equipment on.
2. Use the function selector to select TUNER mode.
3. Use the radio band selector to select the desired band (AM, FM or FM-Stereo).
Turn and hold the tuning knob for a few seconds to tune into a radio station. The
4.
unit will start searching automatically and stop when a radio station is found.
Release the knob once a station has been found.
Repeat the above step until your desired radio station is found.
5.
Adjust the volume knob to your desired volume level.
6.
7. AM reception: the receiver has a built-in AM bar antenna. If reception is weak,
slightly rotate or reposition the unit to improve AM reception.
FM reception: the receiver has a built-in FM wire antenna hanging at the rear
8.
cabinet. For best reception, completely unravel and extend this wire.
When you have finished listening to the radio, turn the volume knob in a
9.
counterclockwise direction to switch the unit off. Unplug it from the power supply if
you are not going to use it for a while.
FM and FM-stereo

FM-Stereo : receiving stereo programs. Once a stereo signal is received, the ST icon
will light up on the display.

Phono Operation

1. Open the dust cover and turn the volume knob clockwise to turn the equipment on.
2. Use the function selector to select PHONO mode.
3. Set the speed selector to the appropriate position: 33, 45 or 78, depending on the
record to be played.
4. Set the auto stop control to ON if you want the turntable to stop turning when it has
6