Bluetooth Operation - boytone TR-18CD Operating Instructions Manual

device takes priority over cassette playback.
NOTE:If you won't use the unit for a long time ,you had better take the CD out from the disk
tray door .
AUX IN encoding
1. Use the function selector to select PHONO/AUX mode and then insert a memory device
(USB drive, SD or MMC card).
2. Press the record REC button, it will take 3 - 4 seconds to read the memory device,
then the USB or SD icon will be flashing on the LC display.
3. Press the skip up
or SD) for encoding, then press the record
(You can skip this step if only a USB drive or an SD/MMC card is inserted.)
4. The system will start the encoding mode after a few seconds. During encoding, the
USB or SD icon will be flashing on the display.
5. To finish encoding, press the stop
to PHONO/AUX mode.
NOTE:

The recording speed is 1:1. Recording will take as long as playing the CD (or other
auxiliary input).

The recording format is preset at MP3 bit rate 128 kbps.

Bluetooth Operation

1, Turn the volume knob clockwise to turn on the equipment on.
2, Set the function selector to select TAPE button.
3, Press the MODE button on the front panel once to Bluetooth mode,and the LCD will show
"BT" all the time.
4, Turn on your bluetooth device and scan , "BT" will be found on your bluetooth device.
Paired and connect the unit and your bluetooth device.
5, Play your bluetooth device as normally do, and the music will be played from the unit.
NOTE:
1, Make sure your bluetooth device and the unit is within 10 meters.
or skip down button to select the desired mode (USB
REC button again to confirm.
button. The display will show "END" and return
16