Table of Contents
Advertisement
13)
Do not overload the wall power outlet. Use only power source as indicated - i.e.
230V AC mains.
Avoid installing this unit in places exposed to direct sunlight or close to heat
radiating appliances such as electric heaters, on top of other stereo equipment
that radiates too much heat, places lacking ventilation or dusty areas, places
subject to constant vibration and/or humid or moist areas.
Do not attempt to clean this unit with chemical solvents as this might damage
the finish. Use a clean dry cloth.Operate controls and switches as described in the
manual.Before turning On the power, make certain the AC power cord is plugged in.
Store your CDs, Cassettes in a cool area to avoid damage from heat.When moving the set,
be sure to first disconnect the power cord.
UNPACKING AND SET UP
● Carefully remove the unit from the display carton and remove all packing material from
the unit.
● Unwind the AC power cord and extend it to its full length.
● Unwind the FM Antenna wire and extend it to its full length.
● Place the unit on a stable, level surface, convenient to an AC outlet, out of Direct
sunlight, and
away
from
sources
of
excess
heat, dust, moisture, humidity or
strong magnetic fields.
● Remove the opaque white plastic stylus cover from the phonograph stylus by sliding it
forward and down.
● Discard the stylus cover
● Remove the twist-tie that was used to secure the tone arm during shipment.
● Release the tone arm lock lever.
●
Connect the plug to your AC outlet.
POWER SOURCE
This product is designed to operate on 230V 50/60Hz AC Mains only. Attempting to
operate
this system from any other power source may cause damage to the system,
3
Advertisement
Table of Contents
