[Power Options] - NEC PA803UL User Manual

[POWER OPTIONS]

[STANDBY MODE]
Select the standby mode:
NORMAL ���������������� Automatically transit the standby state and control consumption power based on the projector setting and
the state of the connected device� (→ page 168)
SLEEP �������������������� Maintain the state of sleep� Consumption power becomes higher than the setting of NORMAL� Select this
mode in the following cases:
• For using the HDBaseT IN/Ethernet and HDBaseT OUT/Ethernet ports constantly�
TIP:
• The [STANDBY MODE] setting is not changed by [RESET].
• Consumption power in the STANDBY MODE is excluded from the calculation for carbon saving.
Enabling Direct Power On [DIRECT POWER ON]
Turns the projector on automatically when the power cord is inserted into an active power outlet. This eliminates the
need to always use the POWER button on the remote control or projector cabinet.
Turning On the Projector by Detecting Input Signal [AUTO POWER ON SELECT]
Under the state of standby or sleep, the projector automatically detects and projects synchronizing signal input from
the selected terminals among Computer, HDMI1/2, DisplayPort, and HDBaseT by this function.
OFF ������������������������ AUTO POWER ON SELECT function becomes inactive�
HDMI1, HDMI2, DisplayPort, COMPUTER, HDBaseT*
������������������������������ When the projector detects the computer signal input from the selected terminal, automatically it will be
turned ON and will project the computer screen�
NOTE:
• If you want to activate this AUTO POWER ON SELECT function after powering OFF the projector, interrupt signal from input
terminals or pull out the computer cable from the projector and wait for over 3 seconds and then input signal from the selected
terminal. In case computer signal is continuously input to the projector, however the projector is turned OFF and is in the transition
to SLEEP mode, it will keep SLEEP mode and will not be turned ON automatically. In addition, if signal from HDMI1/2, DisplayPort
or HDBaseT is continuously input to the projector, the projector may be turned ON again automatically based on the setting of
external devices even if the projector is turned OFF and in the condition of SLEEP mode.
• This function is not activated either by component signal input from the computer screen input terminal or computer signal as
Sync on Green and Composite Sync.
[EXAMPLE]
- For connecting plural numbers of projector in a daisy chain� (→ page 147)
- For connecting to a HDBaseT transmission device (→ page 146)
130
5. Using On-Screen Menu