Table of Contents
Advertisement
Chapter 7, Protocol Logging
Control Commands for Protocol Logging
"q" For internal Hewlett-Packard use only.
"r" For internal Hewlett-Packard use only.
"s" Pressing the "s" key will display the current parameters being used on the Sync
Channel.
"t" Pressing the "t" key will display the current parameters being used on the Traffic
Channel.
"u" For internal Hewlett-Packard use only.
"v" For internal Hewlett-Packard use only.
"w" For internal Hewlett-Packard use only.
"y" Pressing the "y" key will display the current parameters used on the system overhead
messages.
"+" For internal Hewlett-Packard use only.
"-" For internal Hewlett-Packard use only.
"," Pressing the "," key will toggle a command mode that displays the Frame Rate
Characters
(see "Forward Channel Frame Rate Characters" on page 142
and
"Reverse Channel Frame Rate Characters" on page
142). Toggling frame rate
indicators off greatly reduces the amount of data logged.
"." Pressing the "." key will toggle a command mode that displays a subset of the the
Test Set's internal control messages, called Status Request Messages. Turning Status
Request Messages off makes it easier to analyze protocol-related data.
145
Advertisement
Table of Contents
